![]() One of the benefits of drywall is how easy it is to take down and replace if it’s damaged. Plus, the entire process will cost more than hanging drywall. There’s no getting around the fact that lath and plaster requires more skill and time to install well. Of course, there are reasons why drywall is more prevalent today than lath and plaster, and here are a few of the most relevant ones: Lath and plaster walls tend to retain less moisture than plasterboard-especially if you opt for metal over wood lath. ![]() Using lath for interior walls is also a good choice if moisture is of concern. ![]() In another win for lath and plaster, it’s also generally better than drywall at stemming the spread of fire within a building. Surprisingly, despite advances in construction technology, many historic buildings are therefore warmer and quieter than modern ones. Compared to drywall, lath and plaster are better insulators, both for sound and for heat. While using strips of wood laths as building tools is a bit old-fashioned, the lath-and-plaster method definitely has its upsides: (Today, metal laths are considered a superior surface for plaster application since a metal lath doesn’t retain moisture like a wooden lath might.) Plaster is then spread over the laths in three distinct coats: the scratch coat, the brown coat and the finish coat. Historically, narrow strips of wood-each a wood lath-were nailed to the frame of the building perpendicular to the wall studs. hanging dried gypsum plaster) most commonly used today. Lath and plaster walls for interiors date back to the 1700s and were widely used until the early-middle of the twentieth century, when their dominance was supplanted by the drywall method (i.e. For exteriors, stucco is typically spread over metal lath (for example, sheets of wire mesh) in at least three layers. While the use of stucco for sculpture and building dates back to centuries, the modern formulation and usage of stucco as the primary component of exterior walls only took hold in the 20th century. As the wet plaster works its way through the frame, it accumulates on the opposite side, creating plaster keys that hold it in place as it dries. The lath-and-plaster construction method is a way of creating walls and ceilings out of plaster or stucco by spreading the material over a wood or metal frame (which are the laths) and allowing it to dry. In fact, if you have the time and resources to install it properly, there are many points in its favor when compared to modern plasterboard. But it would be unfair to dismiss lath out of hand just because it’s an older technique. If the floor that the closet is built on has subfloor, all the better.If you’re unfamiliar with lath and plaster, you’re not alone: These outmoded wall construction materials have more or less been completely replaced by the drywall you come into contact with every day. Half the weight on the shelves will be supported by one of the existing walls the other at the back existing wall and a bit on the new wall. If the side the door is hinged happens to sit on or near a joist, the better the support for the wall. Actually, the wall should be so light in weight there will be, or should be, little or no concern. If the long wall is across the joists, and portions of the wall that are supported by these joists will be fine. To address another valid issue that was brought up about direction the walls over the joists. The top and bottom plates as mentioned in other answers will do the rest. Use enough screws to increase the chances of finding the wood lath to secure the last stud in the wall. The vibration from setting the nail will break off the keys of plaster that hold the plaster up on the wall. The stud at either can be screwed in place. To answer the original question, the studs at either end of the closet will not need to define the dimensions.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |